Zero Latency 4K HDR SDVoE Video Streaming Transceiver over Copper

Model: KDS-8

Part #: 59-001890

High–Performance Video Streaming Transceiver — Streams up to 4K@60Hz (4:4:4) resolution signals over a 10G network interface, providing lossless compression.
Maximum Compatibility — Fully standard and compliant SDVoE™ codec, enables compatibility with other software and hardware streaming platforms.
HDCP 2.2 Compliant, HDR Support, Genlock and Fastswitch Modes Support
High–Speed 10G Network Switch — Managed switch provides: multicast, jumbo frames, IGMP snooping and fast leave.
Analog Audio Embedding — Provides an unbalanced analog audio port for embedding audio into the streaming signal.

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

KDS-8 is a high-performance, zero latency, 4K@60Hz (4:4:4) video streaming transceiver for streaming via Ethernet over copper cable. KDS-8 can be set as either an encoder or decoder. As an encoder, it encodes and streams the HDMI input along with IR, RS-232, and analog audio, over an IP network. As a decoder, it receives the encoded signal and decodes it for output.

High–Performance Video Streaming Transceiver — Streams up to 4K@60Hz (4:4:4) resolution signals over a 10G network interface, providing lossless compression.
Maximum Compatibility — Fully standard and compliant SDVoE™ codec, enables compatibility with other software and hardware streaming platforms.
HDCP 2.2 Compliant, HDR Support, Genlock and Fastswitch Modes Support
High–Speed 10G Network Switch — Managed switch provides: multicast, jumbo frames, IGMP snooping and fast leave.
Analog Audio Embedding — Provides an unbalanced analog audio port for embedding audio into the streaming signal.
Bi–directional IR over IP — Control an IR device located on the decoder side from the encoder and vice versa.
Bi–directional RS–232 over IP — Control a serial device located on the decoder side from the encoder and vice versa.
Video Wall Support.
Multiview Support
Easy, Cost–Effective Maintenance — LED indicators for main power, Tx/Rx mode setting, HDMI video source detection, and Tx and Rx transmission enable easy local maintenance and troubleshooting.
Simple System Management — Remote system management support to enable quick and efficient remote system and device life–cycle management.

AV-over-IP - Yes
Decoder or Encoder Signal Type - Video
Decoder/Encoder Type - Streaming Decoder/Encoder
SDVoE Enabled - Yes
Spec Sheet available - Yes

Operating Temperature (Maximum): 113 F
Operating Temperature (Minimum): 32 F
Depth: 4.57 in
Height: 0.98 in
Shipping Depth (with packaging): 8.35 in
Shipping Height (with packaging): 2.83 in
Shipping Width (with packaging): 13.82 in
Width: 9.09 in
Product Weight: 1.10 lbs
Inputs:
1 HDMI: On a female HDMI connector;
1 IR: On a 3.5mm mini jack
Outputs:
1 HDMI: On a female HDMI connector;
1 IR: On a 3.5mm mini jack
Ports:
1 10GbE Ethernet: On an R–J45 connector;
1 Unbalanced Stereo Audio: On a 3.5mm mini jack;
1 1GbE Ethernet: On an R–J45 connector;
1 RS-232: On a 3–pin terminal block connector
Video: Standards Compliance: 10/12–bit HDR (Point–to–Point and Genlock mode only), HDCP 2.2 &1.4, DVI 1.0,
EXTENSION LINE:
Signal Compression: Ultra–light compression, lossless for most content; Range: Up to 100m in point–to–point mode
Audio: Standards Compliance: Supports pass–through of audio formats including LPCM 2.0/5.1/7.1, Bitstream and HD Bitstream from HDMI sources
Power:
Source: 12V DC;Consumption: 3A
Environmental Conditions:
Storage Temperature: –20 to +70°C (–4 to + 158 °F), 10% to 90%, non–condensing;
Humidity: 10% to 90%, non–condensing

kramer-kds-8-qs (1).pdf 358394 kb - Instructions

Project List

KDS-8 Datasheet.pdf 1168229 kb - Data Sheet

Project List

Suggested Products

DM NVX® 1080p60 4:4:4 Network AV Decoder

by Crestron Electronics, Inc.

DigitalMedia 4K60 4:4:4 HDR Network AV Decoder

by Crestron Electronics, Inc.

DigitalMedia 4K60 4:4:4 HDR Network AV Encoder/Decoder with Downmixing

by Crestron Electronics, Inc.